When and how to replace greenhouse and polytunnel film

Long polytunnel covered with new film

How to tell that the film needs replacing, what to check first, which weather to choose, how tight to pull it and how to fix it to the frame.

Polyethylene film is the most widely used cover for polytunnels: it protects plants well and costs little. However good it is, it has to be replaced at some point. How long it lasts depends on its thickness, its quality (above all its UV stabilisers), the climate and how well it was fitted.

Which film to choose

Single-layer film is cheap, but it usually lasts a season or a year and suits only a mild climate. For harsher conditions choose professional three-layer film, 200 microns thick, with UV protection, an anti-drip layer and a thermal effect – the film we sell carries a 57-month warranty (see the features of professional film). Clear film is the most common.

Better still is double, air-inflated film: the air cushion between the layers insulates, so you save a lot on heating. It needs a little more upkeep, but it pays off. Buy film from a reliable supplier and leave the fitting to experienced people: good film fitted badly never reaches its promised life.

When it's time

Replace the film when it turns yellow or cloudy (less and less light gets through), when it becomes brittle and tears easily or when it has more and more patches. The end of the warranty period is a signal too.

What to check first

Look closely at the old film, especially where it wore out faster than elsewhere. Wear usually starts at the fixing points – loose or faulty profiles or clips – on sharp edges or where the film rubs against the frame. Look for torn or taped areas too and find out why they tore. Replace faulty profiles and remove sharp edges before fitting the new film, or it will tear in the same places.

Which weather

Pick a time when the crop doesn't need protection – between two crops or in summer – and a calm, dry day. Wind tears the film out of your hands, and film wet with dew or rain is heavy, slippery and hard to tension. Watch the forecast and start once the dew has dried.

How it's fitted

A large polytunnel needs a team of 4–6 people. The roll is lifted to the ridge, unrolled along the whole length, then the film is pulled down on both sides and fixed. Follow the frame manufacturer's instructions; if you don't have them, ask for them – or call on our installation team.

Tension is essential. The film should be pulled just tight enough to remove the creases and stop water pooling on the roof, but no more. Film expands in the heat and contracts in the cold: pull it very tight on a hot day and it may split in winter. It is best fitted at moderate temperatures.

Fixing it to the frame

On galvanised steel frames the film is held with aluminium or galvanised steel fixing profiles and wiggle wire, or with clips. They are very strong, can hold several layers of film and can be reused year after year – still, check them at every change.

Double film

With double film, the inflation fan keeps the air cushion between the layers. The pressure must be right: too low and the film flaps in the wind, too high and it is strained for nothing. A pressure switch keeps it constant. More in our tips for looking after double film.

Making the new film last

Some growers paint the frame tubes white where the film touches them, so they don't heat up and wear it. On galvanised steel frames this isn't necessary. Instead, keep the film clean, repair any tear at once with special tape and check the profiles regularly.

Planning a greenhouse or a polytunnel?

Our team can help you choose the structure, the film and the equipment for what you want to grow.

Back to the blog

Chat on WhatsApp