How to get rid of condensation in a greenhouse or polytunnel

Multi-tunnel greenhouse with roof vents

Condensation forms when leaves are colder than the air. How low-level heating – pipes, underfloor, under-bench or warm air – helps you prevent it.

Condensation is a cold-season problem. It forms when the leaf surface cools below the dew point of the air: moisture settles as water on the plants, and the damp encourages disease. Ventilation and air movement help, but heating plays an equally important part – more precisely, where the heat comes from.

The basic rule: the lower and closer to the plants the heat starts, the more the leaves stay above the dew point, and the more efficiently energy is used. Here are the main systems and how to place them.

Heating pipes

The most common system is a network of metal or plastic pipes carrying hot water or steam. The pipes warm the air by convection, and the leaves directly by radiation. Efficiency improves a lot when the pipes come down next to or under the crop:

  • low-mounted pipes can save up to 20% of the energy, because they heat the plants more directly and less heat is lost;
  • warm air rising through the leaves carries the moisture away and creates an even microclimate;
  • pipes work best at the height of the lower and middle part of the crop, as close to the plants as possible.

Lowered pipes must withstand the chemicals used in the greenhouse, must not get in the way of the work, and must be far enough from the leaves not to scorch them.

Underfloor heating

Pipes can also be laid under the greenhouse floor. The main advantage is even heat over the whole area: warm air rises through the plants, and the warmed root zone helps them stay healthy and grow. The drawbacks are the installation cost and the slow response to temperature changes, so underfloor heating is often backed up by a fast-acting warm-air system. The cost is recovered through efficiency, sometimes within a year.

Under-bench heating

Some growers fit the pipes directly under or on the cultivation benches. The heat reaches the roots, and warm air rises through the plants, so moisture no longer lingers on the leaves.

Warm-air heating

Warm-air heaters are the fastest-acting systems. The warm air is spread by recirculation fans or through perforated polythene ducts. The same fans keep the air moving all the time, so the temperature stays even across the greenhouse and the risk of disease drops; studies show that bringing warm air close to the plants greatly reduces Botrytis infections.

The drawbacks: the fans use energy, and warm air heats the leaves only by convection, so the leaves cannot get warmer than the air around them.

In short

Bring heat sources as close to the crop as you can: the plants stay above the dew point, condensation and disease decrease, and energy use falls. Combine heating with effective ventilation, especially in large modular greenhouses.

Planning a greenhouse or a polytunnel?

Our team can help you choose the structure, the film and the equipment for what you want to grow.

Back to the blog

Chat on WhatsApp