Drip irrigation and fertigation

A water drop on a drip irrigation line

Why drip irrigation saves water and how to apply fertiliser correctly through fertigation: when to inject, for how long and how to flush the system.

In recent years climate change – above all extreme heat and the lack of summer rain – has become a serious problem for everyone, and especially for growers, who have to adapt their crops.

Irrigated crops call for techniques that save water, the energy or fuel used for pumping, and fertiliser. That means micro-irrigation or, more simply, drip irrigation. Applied correctly, it raises both yield and quality. And fertigation – delivering fertiliser with the water – adds one more advantage: the work can be automated.

Drip irrigation

Fertiliser can be applied through any irrigation system, but in vegetable growing drip irrigation is the system most used for fertigation. It applies water slowly, straight onto the soil around the plants, and generally uses less than half the water of a system that sprays it (misting, micro-sprinklers and so on). Drip irrigation is more than 90% efficient, against 50–70% for sprinklers, because:

  1. the water enters the soil before it can evaporate or run off where it is not needed;
  2. the water goes only where it is needed, next to the plants, not over the whole soil.

Because it waters only the crop row, drip irrigation also reduces weeds between the rows. Leaves, stems and fruit stay dry, which makes conditions less favourable for many diseases. Growers with variable water supplies also appreciate the low working pressure: about 0.5–0.7 bar at the drip line. Successful fertigation needs a well-maintained, efficient drip system.

Fertigation: feeding throughout the season

Fertigation is part of the crop's nutrient management plan. Dissolved nutrients are available to the plants as soon as they are applied, so the grower has better control over what the crop receives and uses fertiliser more efficiently. Nutrients can be applied daily, weekly or less often, according to the plan. Applied shortly before the plants need them, less is lost from the root zone – which matters especially in rainy areas and for nutrients that leach easily, such as nitrogen.

When to inject fertiliser into the irrigation system

Apply the nutrients towards the end of the watering, so that most of them reach the root zone. After fertigation, let clean water run through the system to flush out any particles that could clog the emitters.

To know when to start injecting, you need a few figures. First, find out how long the water takes to travel from the injection point to the farthest emitter – watch and note this during the first runs of the system. Then find out how long it takes to inject the amount of nutrients you want. A natural food colouring injected as a marker helps you follow the solution.

Start injecting before the end of the watering by a time equal to the sum of:

  1. the time the water takes from the injection point to the farthest emitter;
  2. the time needed to inject the nutrient solution;
  3. the time the last of the solution takes to reach the farthest emitter;
  4. a little extra to flush the system with clean water.

After injecting, the nutrients must be flushed out of the system completely, to keep the drip lines clean and unclogged.

Fertigation equipment

A fertigation station doses fertiliser and acid automatically. The Shaker Pro station, for example, has a 100-litre mixing tank, four fertiliser injectors and one acid injector, pH and conductivity (EC) sensors and a controller that manages up to 20 fertigation recipes and 20 independent irrigation programmes. You set the pH and EC you want and the share of each fertiliser, and the station injects exactly what is needed to keep the water at those values.

You will find the station's brochure on the downloads page.

Sources: Forigo and eOrganic.

Planning a greenhouse or a polytunnel?

Our team can help you choose the structure, the film and the equipment for what you want to grow.

Back to the blog

Chat on WhatsApp